Use the Magnet Only for Lifting - Magnets don’t wear out as often as they break due to improper use. Never drop the magnet to break up scrap or use it as a hammer—it’s a costly mistake.
Set the Magnet Down Gently - Rough handling leads to expensive repairs. Ease the magnet down onto the pile to prevent internal damage and avoid costly downtime.
Keep Bolts Tight and Replace Broken Ones - Loose or broken bolts allow moisture in and weaken the magnet’s lifting power. Regular maintenance prevents damage and extends longevity.
Keep the Magnet Dry - Never cool a magnet with water, and always store it off the ground on blocks or a platform. Moisture causes short circuits, reducing lifting power.
Monitor Temperature When Handling Hot Scrap - Overheating weakens magnet performance. Switch to a spare magnet when necessary to prevent damage.
Keep the Terminal Box Closed - Protect electrical components from moisture and damage by ensuring the terminal box stays closed. If the cover is missing, replace it immediately.
|
| Wait Before Powering On - Keep the power off until the magnet fully settles on the pile. If you power it on too soon, small pieces will jump up and block larger material, reducing your load capacity.
Let the Magnet Reach Full Strength - After turning the power on, give the magnet a few seconds to build peak magnetic force. This ensures you get the maximum load on every trip.
Work on Deep Piles - A deeper pile allows the magnet to take a full “bite” out of the scrap, increasing your efficiency with each lift.
Turn Power Off During Return Trips - A constantly powered magnet heats up, reducing its effectiveness. Discharge the load quickly, turn the power off, and let the magnet cool between lifts.
Consolidate Scrap into One Large Pile - When only small piles are left, use the magnet to gather them into one large pile to reduce small trips. This streamlines the process and boosts efficiency—one big load trip is three times faster than making three small load trips.
|
|
